Tektronix Applications Expert

Please find the location to download FlashWizard and its release notes here: https://www.tek.com/en/support/software/firmware/c12

SignalVu-PC can be downloaded at the link below:

https://www.tek.com/en/support/software/application/signalvupc-vector-signal-analysis-software--v410022

The TDS2022 did not have customer upgradable firmware. You can create an RMA for calibration and state you need the firmware updated and Tektronix can do that during calibration at our factory service center, see contact information below:

To set up a repair RMA (model and serial number)
call 1-800-833-9200 opt 2. Or 1- 800-438-8165
Or send an email to rmarequest@tektronix.com
Or https://www.tek.com/en/service-quote
Or https://www.tek.com/en/services/repair/mytek_rma_request

The P2220 is a good option for working with the TDS 224

If you are interested in placing order or parts pricing, please reach out to our sales at 1.800.833.9200 option 1 or email the request to buy@tektronix.com.

Yes, the number of frames will increase as the memory is increased.

The CMOS checksum error is most likely the result of the CMOS battery on the processor board needing to be replaced.

You can access the BIOS by pressing the Del key at power on and select Optimized Defaults- then save and exit. The oscillosope should boot up, or there are other issues.

To save/export data from the scope you can open the File > Save As menu on the scope. For a full breakdown of the steps you can view page 173 of the instrument help document here:

https://www.tek.com/en/manual/oscilloscope/456-series-mso-help-5-series-mso

Tektronix offers the TRG101 adapter to use digital channels as a external trigger input. This would also require the MDO3MSO license to use the digital probes for the adapter.

Here is a link to our export classification information:

https://www.tek.com/en/support/export-codes

Here is a link to our export classification information where the ECCN codes can be found:

https://www.tek.com/en/support/export-codes