-
MSO58 standby mode average power consumption
Can you tell me what is the average power consumption of the MSO58 when it is in standby mode?
-
TDS794D available equivalent
Can you suggest the closest equivalent unit available to replace a TDS794D Digital oscilloscope (4CH, 2GHZ, 4GS/S, 8M BW)?
-
DPO4AUTOMAX Availability?
Greetings,
Is the DPO4AUTOMAX Application Module still available?
I'm having trouble finding one...
-
MDO3054 Automaticaly Toggling Relay
I have a MDO3054 that began randomly triggering relay when I was performing measurements, with or without any input on the probes or change of settings. The relay has no effect on the result. It's an audible click when it triggers. Do you know what could be causing this?
Also, I we use the TPP0500B series probes with our oscilloscopes, and I notice that the scope says that “Termination is set by TPP0550B”. Am I correct in assuming that with a TPP0500B plugged in the operator should not be able to alter the termination manually via button or programming?
-
THM565 Schematic
Greetings, My THM565 has failed. Upon examination I discovered that 4 electrolytic caps had failed. I have checked some obvious voltages, but I'm stuck. Is there a schematic available?
-
API for Linux interface for RSA306B?
I am looking for a way to receive raw data from the RSA306B using USB 3.1 connection on the RSA306B.
The data sheet mentions this possibility, but I was not able to find any documentation.
I am hoping to use this device for "Partial Discharge and Fault Detection of Critical High Voltage Transformers and Switchgears" in an academic setting.
-
TDS3014C replacement?
Can you suggest a replacement for the TDS3014C?
-
RSA 507A and OMNI-A0112 antenna issues
I'm having trouble getting my new OMNI-A0112 antenna to work with my RSA507A. I have an older antenna that showed up automatically in the RSA's antenna section, but this doesn't appear to be the case for the OMNI. Do you have any suggestions as to how to resolve this?
-
AWG70002B Always Rebooting Continually
When my AWG70002B tries to load it continually REBOOTS and I'm seeing ERROR CODE: 0XC000021A
-
2230-G-30-6 Altitude Specification
Hello,
Per the datasheet, the Keithley 2230-G-30-6 is rated to 2000m. We have an application that requires a power supply with comparable electrical performance at 3800m.
What is the limiting factor or the Keithley 2230-G-30-6 to operate above 2000m? Has it just not been qualified to that environment? Or is there a specific technical issue that is likely to occur?
Could Tektronix recommend a comparable unit that is rated operational at 3800m?